Saturday, July 30, 2011

energy recovery Lamps - Benefits and Drawbacks

energy recovery Lamps - Benefits and Drawbacks


What are energy recovery Bulbs?

Conventional filament bulbs (including halogens) give out less than 20% of the energy they use as light, the rest is heat. Thus, they are not efficient for the purpose for which they are designed. Some people argue that this has underground benefits, because they contribute to the heating of the room they are in. I think this does not stand up to close scrutiny for two reasons: (a) you often need light in summer, when you do not want heat (b) as most light bulbs are near the top of a room, and hotter air is at the top anyway, they mainly keep the top warm, and dinky heat gets lower down where it is more useful.

Lamps & Light Fixtures Wall Lamps Swing

More efficient bulbs (energy recovery bulbs) have been available for many years. These have been traditionally ageement fluorescents, and these are still the most coarse form of energy recovery bulb. Early types were not so popular, because they were big, took a primary time to reach full brightness and were expensive. They have been improved, so that they are now much smaller, reach full brightness in a matter of seconds or less, and are considerably cheaper.


Check Price on - Lamps & Light Fixtures Wall Lamps Swing Products

The next generation of energy recovery bulbs will be 'light emitting diode' types (Leds). These are an order of magnitude more efficient again, but at the gift stage of development, they are not entertaining sufficient for most lighting. Some Led bulbs are starting to become practical alternatives though; notably those designed to replace Gu10 or Mr16 halogen bulbs. If you are inspecting this, you should note that the white Led bulbs have a slightly bluish tinge, which is quite attractive, but may look odd if mixed with other types of light. Other benefit of Leds is they are available in colours, at no extra cost.

What Types of energy recovery Bulbs are Available?

There is now an energy recovery bulb, of one type or another, that will replace any coarse household bulb, with the irregularity of capsule halogens - these are the very small halogens, that look like a capsule. If you want to use energy recovery bulbs, avoid light fittings that take this kind of bulb.

Some fittings will take energy recovery bulbs only, so you have no choice. recent construction regulations in the Uk stipulate that a definite proportion of lighting in new builds must be energy saving. Thus, fittings are put in that will only take this type of bulb. It is unfortunate that these bulbs tend to be more expensive than those which replace commonplace bulbs, probably because there is greater request for the latter.

Benefits and Drawbacks of energy recovery Bulbs

The benefits can be summarised as follows:
They use about one-fifth the electricity of filament lamps (less in the case of Leds).
They last at least six times longer than filament lamps (much more in many cases).
They run cooler, so do not damage light fittings as much as filament lamps, so higher light outputs can be used, e.g. A lampholder which takes a maximum of 60W filament lamp, will take an 18W or more low energy bulb, giving the equivalent of 100W or more lighting.
Over the lifetime of the bulb, there will be primary savings on electricity bills, and thus carbon emissions connected with electricity consumption.

Possible drawbacks are:
Usually they are more expensive to buy in the first place, but this cost is fast recouped.
Compact fluorescents are not available in clear, only white or coloured.
Most (but not all) are bigger in size than conventional bulbs.
Cannot be used with dimmer switches (except the new type of dimmable ageement fluoescents).
Most protection light manufacurers (with Pirs) recommend against their use, but with contemporary Cfls I have used them in protection lights with no ill effects; they take a dinky longer to come on, but this is not normally a qoute unless a consolidate of seconds is important.

Typical Savings

These figures are based on typical Uk costs of 8p per unit of electricity (a kWhr) with a bulb on for 4 hours per day midpoint and a bulb lifetime of 8000 hours, compared with 1000 hours for a conventional bulb. (You can get longer life bulbs of both types, but they cost more). I have taken a 20W low energy bulb and an equivalent 100W conventional bulb. The costs of the bulbs have been taken from the author's website.

Running costs alone save £9.34 per year.
Running and exchange costs over lifetime of the low energy bulb (5.5 years) £53.18 - this is equivalent to a recovery of about one-quarter of a tonne of Co2 emissions.

And this is just for one bulb. Imagine the savings if all your bulbs were replaced.

Good for your electricity bills and good for the environment.

energy recovery Lamps - Benefits and Drawbacks


==================== Products By Amazon ====================

Hammering & Pounding Baby Toys - Baby Products - Ball Pounding Toys - Wooden Toys - Miracle Toy

No comments:

Post a Comment